I like long-tail CO. I like the neat edge of what would be considered the “purl” side. But how often have you CO 200 of 220 and run out of yarn, ripped, CO again only to have 3 yards of extra tail at the end?
The answer: don’t.
Here’s what to do. Use two tails of yarn, either from two separate balls of yarn or a tail from the inside and a tail from the outside of a center-pull ball. Here I have two separate balls of yarn:
Leaving at least 3″ on each tail, tie the ends together with a slip-knot:
Slide the slip-knot onto your needle and tighten it up:
Now separate the two working strands as if they were one long strand and work long-tail CO as usual.
When you have all 500 +/- sts CO (do NOT count the initial slip-knot), cut one of the working strands, leaving a tail that you can later work in. Begin knitting with the un-cut strand of yarn and when you come to the other end of your CO, get rid of that end slip-knot, just slide it off the needle and pull out the knot.
No more frustration!